Valve tools
Whether it's a valve change, tire mounting or thread repair: with the right valve tool, every step is faster – and safer. Because a valve pulled in at an angle, a damaged thread or a scratched alloy wheel cost more time in tire service than any tool will ever save.
In this category you will find tools for the professional mounting and removal of tire valves – from valve core tools and valve core removers to pulling levers and pliers, all the way to thread chasers and clamping brackets for commercial vehicles.
Filter products
–
Popular valve tools
These are the tools most frequently used in tire service – from the valve core through to thread repair. In addition, this category includes TPMS valve tools as well as clamping brackets and clips for truck valve extensions.
Valve core tool
The standard tool for fitting and removing valve cores – available in single, double and combined versions.
Valve pulling lever
Pulls snap-in valves straight into the rim hole. A tilting joint and long lever arm ensure reliable guidance and controlled force.
Valve pulling pliers
Clamps the valve instead of screwing onto it – which means it can even be pulled in with the valve cap fitted. For steel and aluminum rims.
Thread chaser
Re-cuts damaged valve threads and makes a quick repair possible. Made of tool steel, with a corrosion-protected surface.
What to look for in valve tools
- Match to the valve type: Snap-in, clamp-in and TPMS valves place different demands on the tool. The same applies to the vehicle type.
- Rim protection: Soft plastic shafts and plastic protection on metal parts prevent damage to alloy wheels.
- Angle guidance: A tilting joint and locking notches on the pulling lever prevent the valve from being pulled into the rim hole at an angle.
- Material quality: Tool steel and a corrosion-protected surface pay off in continuous use.
- Defined torque: With TPMS valves, a torque limiter protects the thread against overloading.
- Ergonomics: A long lever arm and a grippy housing reduce the effort required when carrying out many installations in succession.
Frequently asked questions about valve tools
For a standard valve change on a passenger car, a valve core tool or valve core remover for the valve core and a pulling lever or pliers for installing the new snap-in valve are usually sufficient. For commercial vehicles, agricultural and earthmoving machinery, additional tools such as thread chasers or clamping brackets may be required, depending on the valve type.
The decisive factor is that the valve is pulled straight through the rim hole and not at an angle. Pulling levers with a tilting joint and locking notches guide the angle reliably, while the long lever arm allows force to be applied evenly. With pliers featuring a clamping device, the valve does not have to be screwed onto a threaded connector – it can be pulled in with the valve cap still fitted.
A thread chaser re-cuts damaged valve threads and thus makes a repair possible instead of replacing the entire component. This speeds up valve repair considerably. The tools are made of robust tool steel and have a corrosion-protected surface.
Yes. Make sure to choose tools with a soft plastic shaft or plastic protection on the metal parts – these prevent damage to the rim surface. Pliers for snap-in valves with a clamping device are equally suitable for steel and aluminum rims. Special versions for alloy wheels are also available for clamping brackets.
With TPMS valves, even tightening is important in order not to overload the valve thread. Valve core tools with an integrated torque limiter deliver a defined, reproducible tightening torque and protect the thread against damage.
Clamping brackets and clips made of galvanized steel are used for the professional installation of (highly) flexible truck valve extensions. They are available as single and double clamps, with a joint, and in a special version for alloy wheels.